Now we have arrived to this question
How to make the hole?
The procedure is to make first hole for Tivra madyam Low ( A Side hole,90 degree axis to the normal holes axis), then for Dha,Ni,Sa,Re,Ga,Ma
First we have to make small hole, and we have to increase it slightly by slightly we have to consistently check its frequency, when we obtain correct frequency and note, we will move to the next hole making
We can increase only the hole diameter so be careful, if you go fast then you will obtain the pitch sharp and the note will be sharp, and it will be permanent for that flute. ( there are some ideas but for making good flute, it is not advisable to make this patches)
2 comments:
What do you recommend using for making holes? A hot iron rod? If so, what should be the diameter of the rod?
Generally the Hot Pointed iron rod with lesser slope is used for holes making.
By pressing it inside the bamboo, we can increase the diameter, when we are near to our frequency use round file to enlarge the hole very slowly. it will give good finish also.
Post a Comment
Note: Only a member of this blog may post a comment.